Water-Saving Sprinkler Irrigation
This fully automated device stops watering without any manual input when the ground is already saturated by rainfall.
Features discs inside the unit that absorb rainwater allowing communications between the rain sensor and controller.
Innovative hygroscopic technology enables the discs to dry out at a similar pace to most turfed and landscape areas.

Tailor Watering to your Requirements
Fully adjustable from 3mm, 6mm, 12mm and 19mm of rainfall, simply rotate the cap on the switch housing so the pin sits in the required slot.
The built-in vent ring can be easily adjusted to speed up or slow down the drying time to vary the evaporation rate dependent on your soil type.

Built-to-Last
With no maintenance required, the unit can be left out over winter with no need to cover it.
Made from a debris-tolerant design and housed in UV and corrosion-resistant plastic for reliable operation and no unnecessary shutdowns.
5-year trade warranty.

Simple Installation
Complete with 7 metres of 0.5mm² sheathed, UL-approved wire for installation with all Hunter Controllers. For further information, read the Installation Guide.
Easily mount to the gutter using the mounting arm and aluminium bracket complete with fixing screws. The fully adjustable mounting bracket allows flexible installation on angled and perpendicular surfaces.
For best results, ensure the sensor is installed above the irrigation controller and in a location fully exposed or obstructed to any rainfall.

• Height: 5cm
• Length: 15cm
• Width: 2.5cm
• Switch Rating: 24VAC: 3 A