Use to stop the flow of water at the end of a run 14mm pipe. Easily remove when flushing a system without having to cut the pipe or use additional connectors. See Full Description
Use to stop the flow of water at the end of a run 14mm pipe. Easily remove when flushing a system without having to cut the pipe or use additional connectors.
Compatible with 14mm LDPE Pipe or 14mm Drip Line. Ideal for use in micro-irrigation/emitter systems or domestic underground pop-up sprinkler systems that function at optimal pressures between 0.5 bar to 3 bar pressure. Use a pressure reducer at the start of your irrigation system to regulate the pressure to the correct level.
Healthy Plants
The fold-over mechanism reduces any risk of pipe dislocation for a reliable watertight connection. An end cap should be installed at any open end of a system to maintain pressure ensuring emitters can function at their optimal level. The pipe must be heated for 30 seconds in hot water before installation.
UV Resistant
Made from high-quality UV stabilised materials for long life and protection against deterioration when exposed to sunlight. The robust raw materials this connector is made from means it can easily withstand bar pressures required for low/high volume irrigation systems.
Irrigation Fittings Frequently Asked Questions
My connector has a different size printed on the fitting – I have received the wrong product!
The external diameter is printed on the surface of a barbed and nut lock fitting however, compatible Drip Line, Soaker Hose and LDPE Pipe are quoted by their internal diameter. For easy identification of the compatible pipe, you will see our barbed and nut lock connectors listed with their internal diameter because connectors push inside the pipe. As barbed and nut lock connections must be tight to ensure a secure, watertight seal, we advise heating the pipe in boiling water before installation to make insertion easier.
What size connector does my irrigation supply pipe need?
Irrigation pipe is compatible with connectors the same size as the pipe’s internal diameter. For a more secure connection with minimal risk of pipe dislocation, use connectors 1mm larger than the internal diameter of your pipe to ensure a watertight seal.
How do I connect LDPE/drip line to a garden hose pipe?
The soft PVC structure of a garden hose is not compatible with barbed or nut lock fittings as these connectors require the rigid pipe structure of drip line or LDPE to lock onto. To connect drip line or LDPE pipe to a garden hose, connect a Barbed Director to a Quick Click Tap Connector by simply threading them together. Connect the LDPE pipe or drip line to the barbed outlet and install the Hose Pipe to the quick-click tap connector via a Hose End Connector.
My barbed connectors keep coming loose from my irrigation pipe!
Loose barbed fittings indicate either the incorrect-sized connector has been purchased or the pressure running through the system is too high. Too much pressure will cause barbed connectors to dislocate from the pipe. Check that the pressure running through your system is regulated to the correct level using a Pressure Reducer at the start of your system and install a Ratchet Clamp at each connection point to secure the pipe in position.
Can barbed fittings be used with MDPE or HDPE pipes?
Yes, barbed fittings are ideal for sub-surface installation up to 15cm and are capable of withstanding bar pressures required for a small domestic underground sprinkler irrigation system. Top Tip: Before burying the system underground, install a Ratchet Clamp to secure each outlet and check each connection is watertight.
How do I branch off micro pipe and micro dripline from irrigation pipe?
Please Note: Branching off 4mm drip line from 14mm or 18mm drip line should be avoided as piercing holes in the sidewall can impact the pre-determined output of emitters. Instead, branch off micro drip line using LDPE as the header pipe.
